BS-21 EXEN

Beacon BS-21 EXEN

This Ex aproved beacon is made of anodized aluminum alloy and powder coated to assure the quality of the product.

 

  • Lens available in: Clear, Red, Yellow, Green, Blue
  • IP rating: IP66
  • Weight: 2,4kg 
  • Max /Min temperature: 58 C / -50C

 

 

Installation, Operation and maintenance

  • Secure the BS-21 ExeN Flashlight to ceiling or wall with three screws, two washers must be used for each hole.
  • Termination is accessed in e-chamber, by removing aluminum lid fastened with four screws.
  • Be sure that the Ex-product is connected to the correct voltage, and current stated on labels on the model.
  • The lid screws for the termination chamber should be fastened with a torque of 2 Nm to assure the IP-rating.
  • Use only correctly certified cable glands/bling plugs. Reflecting the same IP & temp. spec. as stated on certified label.
  • Outside earthing: Use enclosed pan/washer. Min 4mm² wire.
  • Inside earthing: Use marked earth screw. Min.cross section equal to one of the wire on incoming cable.
  • Delivered with 2 x M20 plastic Ex blanking plugs.
  • WARNING: Do not open this Ex-product when energized.
  • This Ex-product shall only be used in an area of low risk of mechanical danger.
  • This product is supplied with a two years warranty against defective materials and workmanship.